33Changing the opening direction of the doorsBefore carrying out any operations, remove the plug from the power socket.To change the opening direction of the door, proceed as follows:1. Remove the upper hinge and the upper supporttakingcare for the upper door not to fall off ;2. remove the upper door;3. unscrew the middle hinge. Unscrew the plastic plugslocated on the opposite side of the central hinge andintroduce them in the holes occupied before by thehinge;4. remove the lower door;5. pull off the ventilation grille which is fixed by twoscrews;6. remove the bottom hinge by unscrewing its fixingscrews;7. using a 12 mm spanner, unscrew the hinge pin andreassemble it on the opposite side of the hinge;8. adjust the level of the appliance by screwing out theadjustable foot, or feet, at the bottom of the cabinetusing your fingers or a tool;9. reassemble the lower hinge on the opposite side,usingthe screws previously removed. Slide the hole cover outof the ventilation grille by pushing it in the direction ofthe arrow and reassemble it on the opposite side;10. refit the ventilation grille , fixing the screws;11. reassemble the lower door;12. reassemble the middle hinge on the opposite side;13. replace the upper door.14. In your documentation bag you will find the upperhingeand the upper support necessary to make the reversibility. Please mount themintheir relevant place.15. Depending on the model:Model with bar handleDismantle the handles and reassemble them on the opposite side. Cover the holeswith the plastic lids that were situated where the handles are presently.