AEG SANTO Operating Instructions Manual

Also see for SANTO: Installation instructions Installation instructions Installation instructions Operating instructions Operating instructions

46Electrical ConnectionA properly installed socket outlet with earthing contact is required forelectrical connection. Electrical fuse protection must be of at least 10ampere.If the outlet socket is no longer accessible after installation of theappliance, appropriate measures must be taken during electrical instal-lation to assure that the appliance can be disconnected from the mains(e.g. fuse, circuit breaker, non-operate current safety-switch or the like,with a contact opening of at least 3 mm).0 Before initial start-up, refer to the appliance rating plate to ascertain ifsupply voltage and current values correspond with those of the mainsat the installation location.e.g.: AC 220 ... 240 V 50 Hz or220 ... 240 V~50 Hz(i.e. 220 to 240 volts alternating current, 50 Hertz)The rating plate is inside the appliance at the left.Warning: To avoid potential danger, if the mains connection lead ofthis appliance is damaged, it must be replaced by our customer servicerepresentative or a person with similar qualifications.Warning: Under no circumstances should the appliance be connectedto electronic “power saving plugs” or to a.c.-d.c. converters which con-vert direct current to 230 V alternating current (e.g., solar installations,ship networks)Reversing The DoorThe door hinges can be changed from right (as supplied) to left ifrequired to suit the location where the appliance is installed.1 Warning! Unplug from the mains, before reversing the door.0 1. Open the freezer door and with-draw the base mask to the front.At the same time, press on thebase mask from above. Transferthe door bearing covers on thebase mask from left to right.