AYA A22AC2201 Operaing Instructions

Also see for A22AC2201: Operating instructions

Contents

AYA A22AC2201 Operaing Instructions Manual pdf 42 page image

English - 40 -HDMI 1SPDIFCoax.OUTScart Cable(not supplied)External deviceNote• : These three methods of connection perform thesame function but in different levels of quality. It is notnecessary to connect by all three methods.Remote Control HandsetInserting BatteriesRemove the battery cover located on the back of•the handset by gently pulling backwards from theindicated part.Insert two• AAA/R3 or equivalent type batteriesinside. Observe the correct polarity (+/-) wheninserting batteries and replace the battery cover.Note: Remove the battery from remote controlhandset when it is not to be used for a long period.Otherwise it can be damaged due to any leakage ofbatteries. Remote range is approximately 7m/23ft.Connecting to a DVD Player viaHDMIPlease refer to your DVD player’s instruction bookfor additional information. Power off both the TV andthe device before making any connections.Note: Not all cables shown in the illustration aresupplied.If your DVD player has an• HDMI socket, you canconnect via HDMI for better video and audio quality.HDMI 1SPDIFCoax.OUTExternal device(not supplied)HDMI CableWhen you connect to DVD player as illustrated above,•switch to the connected HDMI source. See, InputSelection section for more information on changingsources.Connecting to a DVD Player viaComponent Sockets (YPbPr) orScart CableSome DVD players are connected through•COMPONENT SOCKETS (YPbPr). YPbPr can beused only when you connect a device that has aYPbPr output through the PC input with YPbPr toPC cable (YPbPr cable is not supplied).When the connection is made, switch to YPbPr•source. See, “Input selection” section.To enable audio connection, use the• VGA/Component Audio cable. First, plug single jackof the cable to the TV. Afterwards, insert your DVDplayer’s audio cable’s connectors into the plural partof the VGA/Component audio connection cable(see illustration below). Colours of the connectedjacks should match ( RED & WHITE).AV ConnectionCable (supplied) Audio Cable(not supplied)To DVD Player'sAudio Outputs.SIDE AVWhen the connection is made, switch to• YPbPr source.See, Input selection section.You may also connect through the• SCART input.