Aastra S850i Installation And Quick Start Manual

Also see for S850i: User manual Administrator's guide

Contents

Aastra S850i Installation And Quick Start Manual Manual pdf 6 page image

Installation and Setup3 41-001515-00 REV00 – 06.2013Phone ConfigurationBefore using the S850i for the first time, you will need to select the system language. The six options are English,Español (Spanish), Français (French), Deutsch (German), Italiano (Italian), and Português (Portuguese).Highlight the language of your choice, and press either Enter or Select on the Handset/Dialer to select it. Once a lan-guage is selected, the system will use that language for all screen contents. Please ensure that you select the right lan-guage. If you need to change the selected language later on, this can be done in the advanced setup menu of the Hand-set/Dialer.Connecting to the SIP Call ManagerDepending on your switch, different settings will be required for your S850i to work in your environment. First of all, theS850i will require an IP address. The IP address can either be obtained from a DHCP server in your network, or be stati-cally set on the phone. The phone is preset to DHCP. If you want to change this, please open the menu on the Hand-set/Dialer by pressing the right soft key, go to the Setup menu, and select Advanced Setup. You will have to enter apassword, which is preset to 2222. Now select Network Settings. Under IP Settings you can set the required networkvalues like IP address, subnet mask, default gateway, and DNS servers. You will need to restart the phone for anychanges you made in this section to take effect.If you are using DHCP, you can go to the System Info menu, and select About System. The assigned IP address for theS850i will be shown here. If you configured a Virtual LAN (VLAN) for your voice traffic on your IP network, you need toeither enable VLAN on the Handset/Dialer and provide the VLAN identifier, or select Automatic, in which case the S850iwill try to determine the VLAN settings of your network at startup.Independent on how the IP address of your system was assigned, the S850i phone has to be configured to work in yourVoIP environment and communicate with your IP PBX. You will have to enable the extension (user) you want to use withthe S850i on your IP PBX. Please review your PBX documentation on information on how to do that. For the minimalsetup, in the Handset/Dialer you will have to provide information on the IP connection to the IP PBX. To do this visitMenu > Setup > Advanced Setup > Network Settings > VOIP Settings. Under Registrar, provide the IP address orhost name of your IP PBX. The Username should be the extension or name under which you want to register this phoneon the IP PBX. In Password, provide the password for this username. If no values are provided for ID and Display Name,the Username entry will be used for them. Select Reload Settings after you have set the values in the Handset/Dialer,which will restart the base.If further settings are required to connect the S850i to your IP PBX (e.g. a proxy server) please visit the S850i Web Inter-face. You get to this interface by entering the IP address of the S850i into the web browser of your choice. After youentered the password (2222, unless you changed it in the Handset/Dialer), you can find the SIP settings under theAdministrator tab on the top right. You will find the different SIP settings under SIP Registration, SIP Configuration,Transport, and Media. You have to press Save on every page where you changed an entry to save these changes. If youdo not press Save, the changes will be lost when you leave that page. Restart the phone once you are finished with yourchanges.