Abatron bdiAccess BDI1000 Installation Manual
Also see for bdiAccess BDI1000: User manual
                      | |
Contents
| 
bdi Access JTAG interface library, BDI1000 (ARM7/9/9E) Installation Manual 15© Copyright 1992-2008 by ABATRON AG V 1.02BDI IP Address Enter the IP address for the BDI1000. Use the following format:xxx.xxx.xxx.xxx e.g.151.120.25.101Ask your network administrator for assigning an IP address to thisBDI1000. Every BDI1000 in your network needs a different IP address.Subnet Mask Enter the subnet mask of the network where the BDI is connected to.Use the following format: xxx.xxx.xxx.xxxe.g.255.255.255.0A subnet mask of 255.255.255.255 disables the gateway feature.Ask your network administrator for the correct subnet mask.Default Gateway Enter the IP address of the default gateway. Ask your network administra-tor for the correct gateway IP address. If the gateway feature is disabled,you may enter 255.255.255.255 or any other value.Transmit Click on this button to store the configuration in the BDI1000 flashmemory.2.6.3 Recover procedureIn rare instances you may not be able to load the firmware in spite of a correctly connected BDI (errorof the previous firmware in the flash memory). Before carrying out the following procedure, checkthe possibilities in Appendix «Troubleshooting». In case you do not have any success with thetips there, do the following:• Switch OFF the power supply for the BDI and open the unit asdescribed in Appendix «Maintenance»• Place the jumper in the «INIT MODE» position• Connect the power cable or target cable if the BDI is poweredfrom target system• Switch ON the power supply for the BDI again and wait until theLED «MODE» blinks fast• Turn the power supply OFF again• Return the jumper to the «DEFAULT» position• Reassemble the unit as described in Appendix «Maintenance»INIT MODEDEFAULTJumper |
Related manuals for Abatron bdiAccess BDI1000
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine