View GlucoseReview HistoryStart New SensorNo Active Sensor10:23pmminutesNew SensorStarting Up60Sensor can be used in:OKDo not take high dosesof vitamin C (more than500 mg per day). This mayfalsely raise your Sensorreadings. Supplements likeAirborne® or Emergen-C®have high doses of vitaminC. Read labeling for allsupplements to determinevitamin C content.Important OKStart New SensorScan Sensor to start it.Hold the Reader nearthe Sensor.STEP 3STEP 6Get ReadyApply SensorWash site using a plain soap,dry, and then clean with alcoholwipe. Allow site to air dry beforeproceeding.Refer to your User’s Manual for full System instructions and information.TouchscreenHome ButtonUSB PortReaderQuick Start Guide forFreeStyle Libre 3 ReaderSTEP 1STEP 4STEP 2STEP 5Place Sensor Applicator over siteand push down firmly to applySensor.CAUTION: Do not push down onSensor Applicator until placedover prepared site to preventunintended results or injury.Make sure Sensor is secure. Put the capback on the Sensor Applicator. Discardused Sensor Applicator according to localregulations.Gently pull Sensor Applicatoraway from your body.SensorApplicatorSelect site on back of upper arm.Do not use other sites as these arenot approved and may result ininaccurate glucose readings.Note: Avoid scars, moles, stretchmarks, lumps, and insulin injectionsites. To prevent skin irritation,rotate sites between applications.Press Home Button to turn on Reader.If using Reader for the first time, followthe prompts to set up the Reader. Thentouch Start New Sensor when you seethis screen.Review the important information on the screen.Reader will automatically display your glucosereading after 60 minutes.Hold the Reader near the Sensor to start it. Youmay need to move your Reader around slowlyuntil you find the right spot.Note: Before you start your Sensor, choose whichdevice you want to use. If you start the Sensorwith the Reader, you will be unable to use the Appto check your glucose or receive alarms.STEP 3STEP 1 STEP 2Unscrew capfrom SensorApplicator.CAUTION:• Do NOT use if damaged or if tamper labelindicates Sensor Applicator has alreadybeen opened.• Do NOT put cap back on as it maydamage the Sensor.• Do NOT touch inside Sensor Applicatoras it contains a needle.SensorWait 60 minutesfor start-up1 Apply Sensor to the back of yourupper arm2 Start new Sensor with Reader3 After the start-up period, you can usethe Reader to check your glucoseCapTamperLabelSetup Overview1 Apply Sensor to the back of your upper arm2 Start new Sensor with ReaderCONTINUOUS GLUCOSE MONITORING SYSTEM