Quick Start GuideDual Switch Latch and Timerwww.ablenetinc.com1-800-322-0956Product OverviewPN 9008009 (02/20 Rev. C - FN 70500212)UseRequired but not included:Single Switch(es)9-Volt Alkaline BatterySwitch Adapted Toy or ApplianceSwitch 2 - InPlug to Plug adapterto Toy for Switch 2Mode SwitchTimer AdjustBattery CompartmentTimed Seconds - The Timed Seconds mode allows for thetoy or appliance to run for a preset amount of time with asingle activation.Timed Minutes - This mode behaves exactly like the TimedSeconds mode, but uses minutes rather than seconds.Latch - One activation of a switch turns the toy or applianceon; the second activations turns it off. Use the Latch modewhen you want a toy or appliance to remain on indefinitely.Switch 1 - InCable to Toy for Switch 1Plug to Plug Adapter1/8” (3.5mm) phone plug both sidesMost switches give switch users momentary control of theirswitch adapted toys or appliances. Meaning, when you pressyour switch, your toy or appliance will operate only for thetime that you are holding down the switch. The Dual SwitchLatch and Timer gives switch users more control of theirdevices by adding time and latch modes of control.Setup1. Install 9-Volt Battery2. Plug switch in Switch 1 - In jack or Switch 2 - In jack.3. If your switch is plugged into Switch 1 - In jack then plugbuilt-in cable into your switch adapted toy or appliance. Ifyour Switch is plugged into Switch 2 - In jack then use Plugto Plug Adapter to go from the Dual Switch Latch and Timerto your switch adapted Toy or appliance.4. Chose your mode of control using the Mode Switch.5. Adjust the time you want your toy or appliance to operatewith the Timer Adjust knob when in Timed Sec Mode andTimed Min Mode.Modes, Tips, and TricksRecommend using 9-Volt alkaline batteries only.Check battery if Switch Latch and Timer is acting erratically.You can setup two switches into the Switch Latch and timer.The switches will operate their corresponding toy or applianceindependently of each other in the same mode of control.The Timer Adjust knob shows approximately how long the toyor appliance will activate. It is not an exact indication.