AbleNet Big Beamer Quick Start Manual

Also see for Big Beamer: Quick start guide Quick start guide Quick start guide

AbleNet Big Beamer Quick Start Manual Manual pdf 1 page image

3 Wireless SLAT Set-Up (WSLAT only)Quickstart Guide:Big Beamer ™ and Jelly Beamer ™ WirelessSwitch, or Wireless Switch Latch and Timer(WSLAT)www.ablenetinc.comMode ButtonSelect your Mode of Control by repeatedly pressing the“Mode” button.The receiver’s mode lights will indicate which mode is activated.For Timed Modes - Adjust the Timer Dial from 1-60 seconds orminutes as desired.Note: First half-turn of the Timer Dial ranges from 1-10 sec/min.Second half-turn ranges from 11-60 sec/min.1 Powering and turning on transmitters and receivers2 Connecting and ActivatingOnOnPlug the wireless receiver into a device.Press the transmitter’s switch top.Signal lights on both components will light up and theattached device will activate.Note: Big and Jelly Beamer has an effective range of up to 30 feet.Computer access requires a switch interface (not included).DirectTraditional switch behavior - deviceremains ON as long as switch is held.Timed SecondsRuns device from 1 to 60 seconds witheach activation.Timed MinutesRuns device from 1 to 60 minutes witheach activation.LatchFirst activation turns device ON; secondactivation turns it OFF.Programming Tip: Turn the Timer Dial all the way upto 60 and activate the device. As the desired timeapproaches, turn the Dial back down towards 0,stopping the device at the time desired.Modes of ControlInsert two AA batteries into both components as shown on housing.(Big Beamer transmitter uses 2 AAA batteries)Slide the power switches on each component to the “On” position.The components’ lights will activate briefly when the components are turned on.Timer DialLearn ButtonMode LightsOn