Configuration91General tabParameter SettingNIC Type Set the transmission speed of theintegrated network card here.Tip: 10M/100M/1000M Self-adaptive.DHCP Tick the box if the IP addresses onthe network are assigned dynamicallyvia DHCP.DHCP enabled: subsequent entryfields are set to disabled becauseparameters are obtained via DHCP.Note:If the IP addresses are assignedmanually, ensure that DCHP is notenabled (do not tick the box).IPv4 Address Address of the network device on thenetwork when assigned manually.IPv4Subnet MaskUsually 255.255.255.0.IPv4 DefaultGatewayGateway address for internet access.IPv6 Address 1 Local (link local) IPv6 address.IPv6 Address 2 Global (global unicast) IPv6 address.IPv6 DefaultGatewayIPv6 gateway address for internetaccess.MAC address Hardware address of the integratednetwork card.MTU(Bytes) Describes the maximum protocolpacket size.Preferred DNSServerAddress of the domain name server,usually the IP address of thegateway.Alternate DNSServerIP address of the alternative DNSserver.NoteIn certain modes some of these settings cannot beselected.PPPOE tab1. Tick the "Enable PPPOE" box. Then enter your username (internet access ID) and password and confirmyour password.2. Apply the data by clicking on Apply.WarningIf possible, only use PPPOE when no router isavailable.DDNS tab1. To be able to use the ABUS DDNS function, you firstneed to set up an account at www.abus-server.com.Please read the FAQs on this topic on the website.2. Tick the "Enable DDNS" box. Then select "DynDNS"as the DDNS Type and enter the www.abus-server.com IP address in the "Server Address" field.3. Apply the data by clicking on Apply. The IP addressof your internet connection is now updated on theserver every minute.