Configuration92NTP tabNoteThe recorder can synchronise the time with anexternal server. Several server addresses areavailable on the internet for this purpose.1. Tick the "Enable NTP" box and enter the intervalafter which synchronisation should be repeated.Enter the IP address of the NTP server and the NTPport.2. Apply the data by clicking on Apply.Email tabIn the event of an alarm, the device can send a messageby email. Enter the email configuration here.Parameter SettingEnable ServerAuthenticationTick the box when logged onto theinternet provider's serverUser Name Email account with the providerPassword Password used to protect the emailaccountSMTP Server SMTP server address of theprovider.SMTP Port Enter the SMTP portEnable SSL Tick the box to enable emailencryptionSender Name of the senderSender'sAddressThe email address linked to theemail accountSelectReceiversSelect three potential recipients forthe emailReceiver Enter the name of the recipient hereReceiver'sAddressEnter the email address of therecipientEnable AttachedPictureTick the box if camera recordingsshould also be sent with the email asphoto filesInterval Select a trigger time of between twoand five seconds. The pictures willonly be sent if motion is detectedduring the time frame defined.1. Enter the parameters of the email notification.2. Then click on Test to send a test email.3. If you have entered everything correctly and havereceived a confirmation email, click on Apply.NoteThe device will send an email to the specifiedrecipients.If no email is received, check the settings andcorrect them where necessary.If necessary, check the junk mail settings for youremail client.NoteYou can obtain the access data and settings forsending SMTP from your email provider. Someemail providers only provide SSL encryption forsending emails. This recorder has been tested forSSL compatibility with the following providers:GMX, Web.de and Gmail.