Abus TVVR40000 User Manual

Abus TVVR40000 User Manual Manual pdf 10 page image

Important safety information10• To avoid the possibility of fires, the plug should aways be disconnected from the network socket if thedevice is not used for long periods. Disconnedevice from the mains power supply before impening electrical storms, or use an uninterruptible powersupply.WarningNever open the device on your own! There is arisk of electric shocks!If it is necessary to open the device, consulttrained personnel or your local maintenance spcialist.• The installation or modification of a HDD should onlybe made by trained personnel or your local maintnance specialist.WarningThe installation of additional equipment or modifcation of the device invalidates your guarantee ifnot carried out by trained personnel.We recommend having the HDD installed by amaintenance specialist.Your guarantee is invalidated in the event of iproper installation of the HDD.Overloading / overvoltage• Avoid overloading of mains sockets, extension cablesand adapters as this can result in fires or electricshocks.• Use overvoltage protection to prevent damagescaused by overvoltage (e.g. electrical storms).Cables• Always hold cables by the connector, and do notthe cable itself.• Never touch the mains cable with wet hands, as thiscan lead to a short circuit or electric shock.• Never position the device, furniture or other heavyitems on the cable. Ensure that the cable does notbecome kinked, especially on the connector andsockets.• Never knot the cable, and do not tie it to other cables.• All cables should be laid so that they cannot bestepped on or cause an obstruction.• A damaged mains cable can cause a fire or electricshock. Check the mains cable from tim• Never modify or manipulate the mains cable or plug.• Do not use plug adapters or extension cables that donot conform to the applicable safety standards, and donot make alterations to power supply cables or mainscables.To avoid the possibility of fires, the plug should al-ways be disconnected from the network socket if thedevice is not used for long periods. Disconnect thedevice from the mains power supply before impend-ing electrical storms, or use an uninterruptible powerNever open the device on your own! There is aIf it is necessary to open the device, consultpersonnel or your local maintenance spe-The installation or modification of a HDD should onlybe made by trained personnel or your local mainte-The installation of additional equipment or modifi-validates your guarantee ifnot carried out by trained personnel.We recommend having the HDD installed by aYour guarantee is invalidated in the event of im-overloading of mains sockets, extension cablesand adapters as this can result in fires or electricUse overvoltage protection to prevent damagescaused by overvoltage (e.g. electrical storms).Always hold cables by the connector, and do not pullNever touch the mains cable with wet hands, as thiscan lead to a short circuit or electric shock.Never position the device, furniture or other heavyitems on the cable. Ensure that the cable does nothe connector andNever knot the cable, and do not tie it to other cables.All cables should be laid so that they cannot beA damaged mains cable can cause a fire or electricshock. Check the mains cable from time to time.Never modify or manipulate the mains cable or plug.Do not use plug adapters or extension cables that donot conform to the applicable safety standards, and donot make alterations to power supply cables or mainsInstallation location / operating enviroment• Position the device on a firm, level surface and do notplace any heavy objects on the device.• The device is not designed for operation in roomssubject to high temperatures or moisture (e.g. batrooms), or in excessively dusty rooms.• Operating temperature and ambient humidity:-10 °C to 55 °C, maximum 85% relative humidity. Thedevice may only be operated in moderate climateconditions.Ensure the following:• Sufficient ventilation must be presentnot place the device in a storage rack, on thick capets, on a bed or anywhere where the ventilationslots are covered. Make sure that a gap of at least10 cm is present on all sides).• The device must not be exposed to direct heatsources (e.g. heaters).• The device must not be exposed to direct sunlight orstrong artificial light.• The device must not be placed in close proximity tomagnetic fields (e.g. loudspeakers).• Naked flames (e.g. candles) must not be placed on ornear the device.• Contact with spraying or dripping water and aggresive liquids must be avoided.• The device must not be operated in close proximity towater, and must not be submerged under any cicumstances (do not place objects containing water onor near the device, such as vases or drinks).• Foreign objects must not penetrate the device.• The device must not be exposed to strong variationsin temperature, as this can lead to condensation andelectrical short circuits.• The device must not be exposed to excessive jolts orvibrations.Remote control• Remove all batteries if the device will not be used fora sustained period, as these can leak and damagethe device./ operating environ-Position the device on a firm, level surface and do notplace any heavy objects on the device.The device is not designed for operation in roomssubject to high temperatures or moisture (e.g. bath-rooms), or in excessively dusty rooms.Operating temperature and ambient humidity:°C to 55 °C, maximum 85% relative humidity. Thedevice may only be operated in moderate climateSufficient ventilation must be present at all times (donot place the device in a storage rack, on thick car-pets, on a bed or anywhere where the ventilationslots are covered. Make sure that a gap of at leastcm is present on all sides).The device must not be exposed to direct heatThe device must not be exposed to direct sunlight orThe device must not be placed in close proximity tomagnetic fields (e.g. loudspeakers).Naked flames (e.g. candles) must not be placed on orntact with spraying or dripping water and aggres-sive liquids must be avoided.The device must not be operated in close proximity towater, and must not be submerged under any cir-cumstances (do not place objects containing water onas vases or drinks).Foreign objects must not penetrate the device.The device must not be exposed to strong variationsin temperature, as this can lead to condensation andThe device must not be exposed to excessive jolts orRemove all batteries if the device will not be used fora sustained period, as these can leak and damage