Accent 800 Hardware Manual Page 24Attaching, Raising, and Removing a KeyguardYour device came with a frame mounted on it. The Keyguard attaches to the frame. If you removed theframe, reattach it, referring to “Removing or Replacing the Device Frame” on page 20.Attaching the Keyguard1. Hold the Keyguard over the screen, with the pins toward the top of the screen and the tabs towardthe bottom.Important! Position the Keyguard so that the tabs are on the bottom. The tabs must be able to lieflat against the screen, allowing the Keyguard to snap into place.2. Insert one of the Keyguard pins into theopening near the top of the device frame.3. While holding the pin in place, lift upwardwith your fingers to bend the middle of theKeyguard upward slightly. Then insert theother pin into the opening on the other sideof the device frame.4. Press down on the bottom portion of the Keyguard to snap the tabs into place.Note: If the Keyguard tabs at the bottom do not snap into place, make sure that the Keyguard is notupside-down. (See step 1.)
