Accent 800 Hardware Manual Page 26Attaching or Removing a TouchGuideYour device came with a frame mounted on it. The TouchGuide attaches to the frame. If you removedthe frame, reattach it, referring to “Removing or Replacing the Device Frame” on page 20.Attaching the TouchGuide1. Align the TouchGuide so that the two squaresat the top are positioned at the upper rightcorner of the display.2. With the bottom tabs in place, lift upwardwith your fingers to bend the top right cornerof the TouchGuide slightly and insert the tabinto the top right slot of the frame.Then insert the bottom tabs of the TouchGuideinto the slots at the bottom edge of the frame. Note: The TouchGuide plastic is stiff and mayrequire some effort to bend.3. Insert the left tab into the top left slot of the frame using the same method as in step 3. TheTouchGuide is now ready to use.Removing the TouchGuideNote: Avoid pulling on the thin pieces of plastic.1. Grasp the thicker plastic above the first row ofkeyholes.2. Pull out and down on the TouchGuide until theupper tabs pop out.Grasp the thicker plasticPosition squaresin upper rightInsert bottomtab into slot
