Access IS ATR110 Product Manual And User Manual
                                       | |
Contents
| 
Copyright © Access-IS 2015Page 30 of 396.6 Development Commands6.6.1 Firmware and Imager LevelsThe release and build of a unit can be identified by the firmware levels; these can be obtained bysending the command “AISFWV?” as detailed in the following section. For example;SB 01.00.00 is a first generation ATR110.Command Description Default Parameters/RangeAISXXR Simulate read outcome: [0 good read | 1bad read | 2 Ignore]Used in interactive mode to communicate to userafter the host has checked the data. Interactivemode and Host mode only.- 0 - Good Read1 - Bad Read2 - IgnoreAISIOP Interactive mode option flag.Only applicable to interactive mode (AISOMD2).If this flag is set then the TRIG messages from theATR110 are sent only on media detect and mediaremoved, regardless of commands from the host.0 0 - disabled1 - enabledAISRDS Change configuration to default values. - 1AISFWV Return the version of the firmware. - -AIS_WA Returns the firmware version of theimager.- -AIS_TD Returns the timestamp of the firmwarerelease.1 -AISTMD Imager Trigger Mode. 0 0 - Trigger Mode1 - Presentation ModeAIS_BO Enables or Disables Barcode Reading.This command is stored in volatilememory so will return to the default onpower cycle.1 0 - Off1 - OnAISDLE Include DLEs (Data Link Escape). 0 0 - Off1 - OnAISNRD Sets a ‘No Read’ message to be sent atintervals.0 0 - Off1 - 60000 - Time in ms232CRD CTS is raised when a ‘Good Read’output is received.0 0 - Off1 - On232CTS Hardware handshaking - requires theCTS to be high.0 0 - Off1 - OnTo check the latest firmware version or to update firmware, please contact support@access-is.com. |
Related manuals for Access IS ATR110
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine