WEARING YOUR PEDOMETERWhile gently holding the belt clip open, slide the pedometeronto your belt or the top edge of your pants or skirt. It shouldfit snugly and level, above one knee.Note: The pedometer should be as vertical as possible. Walkerswith larger stomachs may find it helpful to wear the pedometerfarther back on the body, toward one hip.The cover must be closed for the pedometer to work. To avoidlosing or dropping your pedometer, use the included leash andclip to fasten the pedometer securely to your clothing.Attaching the Leash: Attach the pedometer to the leash bylooping the leash around the pedometer belt clip. Next, clasp thewaistband of your clothing with the attached metal clip. You canalso use a safety pin to fasten the leash to your clothing, loopthe leash through your belt or belt loop, or use a badge holder.VIEWING YOUR RESULTSOnce you put on your pedometer with the cover closed, it willautomatically begin to record your steps. Repeatedly press theaqua MODE button to cycle through the pedometer modes:DAILY STEPS→TOTAL STEPS→ PACE→ GOAL%→ ACTIVITYTIMER→ DAILY STEPSMEMORY PEDOMETEROPERATING INSTRUCTIONSACCUSPLIT, Inc. • 6120 Stoneridge Mall Rd., Suite 210 • Pleasanton, CA 94588 USA800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • support@ACCUSPLIT.comACCUSPLIT®EAGLE™ 1622M4Eat Right! Walk More! Live Well!The ACCUSPLIT LifestyleCongratulations on taking the first step to wellnesswith your purchase of an ACCUSPLIT pedometer.It’s easy to set up your new pedometer.Just follow the steps below, and start walking!970-067First, loop thepedometer clipNext, loop the metal clip,then clasp clothingOr, loop abadge holder, thenput into pocket(Badge holder not included)Or, loop a belt orbelt loopNO-PROOF-OF-PURCHASE LIMITED WARRANTYSee label inside the lid of the pedometer.AUTO MOVEMENT SENSOR1. To filter out random movements, the unit remains in standby mode until5 continuous steps are registered. Only then are the 5 steps calculated in,and an Active indicator “▲” appears on the upper left of display.2. When regular walk/run movement stops, after 2 seconds the timer pausesand the unit switches to standby status (Active indicator “▲” disappears)RESETTING YOUR PEDOMETERMost people prefer to reset step counts daily. To reset: While displaying Day’sSTEPs, press and hold yellow RESET button for at least two seconds to resetto zero. When displaying Total STEPs, press yellow RESET button for twoseconds to reset Total and Day’s STEPs to zero.GOAL SETTINGYour unit is set to a goal of 10,000 steps per day, as recommended by walkingexperts. To change the step goal, press the aqua MODE button repeatedly untilyou are in GOAL % mode. ACCUSPLIT products follow a standard settingprocedure known as SET1-2-3-4. Press and hold the cream SET button for2 seconds to enter setting mode (SET 1/2). Display will show your daily stepgoal (in steps). Press the cream SET button to increase your daily step goal(SET 3+), in 500 step units. Press the yellow RESET button to decrease yourdaily step goal (SET 3–). Press the aqua MODE button to exit setting mode(SET 4), or simply wait a few seconds and unit will exit setting modeautomatically.REPLACING THE BATTERYWhen the display starts to dim or goes blank, it is time to replace the battery.Your pedometer uses one Type LR43 (L1142) 1.5 volt alkaline battery. Toreplace:1. Insert a coin into the slot on the bottom of the case, and twist counter-clockwise to loosen the case front. Lift case front away.2. Using a pen or other thin object, push battery sideways out of its holder.Replace it with a new battery. The battery’s positive (+) terminal shouldbe FACE UP while you put it into the pedometer.3. Align case front over the pedometer and press gently tosnap cover back into place, starting with top.ACCUSPLIT EAGLE 1622M450 80 100%200GOAL%TW15MGSTEPDAY TOTAL PACE GOAL% MODESET4RESETTARGETMYGOAL™SET1/2SET 3+–425 I Aqua:MODECream:SETYellow:RESETREGISTER NOW Please returnyour AE1622M4 Registration tothe Repair Center address in thewarranty, and we will let youknow about future products.Email (preferred)UserDISPLAY MODES• DAY (Day’s STEPS): Counts steps taken since last RESET.Reset daily to count each day’s steps.• TOTAL (Total STEPS): Keeps track of all steps taken, even afterDay’s STEPS are reset.• PACE: Mode shows rate of stepping in steps/minutes.• GOAL%: Visually shows your progress towards today’s stepping goal.• (ACTIVITY TIMER): Shows total activity time in minutes andseconds since last reset. The timer runs automatically wheneversteps are being recorded.