Accusplit Eagle 1120M2 Operating Instructions Manual

Also see for Eagle 1120M2: Operating instructions

Accusplit Eagle 1120M2 Operating Instructions Manual Manual pdf 1 page image

WEARING YOUR PEDOMETERWhile gently holding the belt clip open, slide the pedometeronto your belt or the top edge of your pants or skirt. It shouldfit snugly and level, above one knee.Note: The pedometer should be as vertical as possible.Walkers with larger stomachs may find it helpful to wear thepedometer farther back on the body, toward one hip.To avoid losing or dropping your pedometer, use the includedleash and clip to fasten the pedometer securely to yourclothing.Attaching the Leash: Attach the pedometer to the leash bylooping the leash around the pedometer belt clip. Next, claspthe waistband of your clothing with the attached clip. You canalso use a safety pin to fasten the leash to your clothing, loopthe leash through your belt or belt loop, or use a badge holder.VIEWING YOUR RESULTSOnce you put on your pedometer, it will automatically beginto record your steps. Press the DAY button to view today’sstep count. Press the TOTAL button to view total steps taken.MEMORY PEDOMETEROPERATING INSTRUCTIONSACCUSPLIT, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551 USA800-935-1996 • 925-290-1900 • FAX 925-290-1930 • www.ACCUSPLIT.com • support@ACCUSPLIT.comACCUSPLIT®EAGLE™ 1120M2Congratulations on taking the first step to wellness with your purchase of an ACCUSPLITpedometer. It’s easy to set up your new pedometer. Just follow the steps below, and start walking!RESETTING YOUR PEDOMETERMost people prefer to reset step counts daily.To reset: While displaying Day’s Steps, press and hold DAYbutton for at least three seconds to reset to zero. Whendisplaying Total Steps, press TOTAL button for three secondsto reset Total and Day’s Steps to zero.AUTO MOVEMENT SENSOR1. To filter out random movements, the unit remains in standbymode until 5 continuous steps are registered. Only then arethe 5 steps calculated in, and an Active indicator “▲” appearson the upper left of display.2. When regular walk/run movement stops, after 2 seconds thetimer pauses and the unit switches to standby status (Activeindicator “▲” disappears).REPLACING THE BATTERYWhen the display starts to dim or goes blank, it is time to replacethe battery. Your pedometer uses one Type L1142 (LR43) 1.5volt silver oxide battery. To replace:1. Using a jeweler’s screwdriver, loosen small screw on back ofunit. Remove back of case.2. Slide the old battery gently out of its holder. Replace it with anew battery. The battery’s positive (+) terminal should beFACE UP while you put it into the pedometer.3. Gently press front and back of pedometer case back together,being sure to line up slots and tabs at top and bottom of unit.ACCUSPLITEAGLE1 1 2 0 M 2T W 1 5 M GTOTALDAYAccuSTEP 10000.orgSTTLMODES• “D”– “Day’s Steps”Counts steps taken since last RESET.• “T”–”Total Steps”Keeps track of all steps taken, even afterDay’s Steps are reset.DAY buttonTOTAL button970-043First, loop thepedometer clipNext, loop the metalclip, then clasp clothingOr, loop abadge holder, thenput into pocket(Badge holdernot included)Or, loop a beltor belt loopREGISTER NOW Please returnyour AE1120M2 Registration tothe Repair Center address in thewarranty, and we will let youknow about future products.Email (preferred)User

/ 1

Related manuals for Accusplit Eagle 1120M2