WEARING YOUR PEDOMETERWhile gently holding the belt clip open, slide the pedometeronto your belt or the top edge of your pants or skirt. It should fitsnugly and level, above one knee.Note: The pedometer should be as vertical as possible. Walkerswith larger stomachs may find it helpful to wear the pedometerfarther back on the body, toward one hip.To avoid losing or dropping your pedometer, use the includedleash and clip to fasten the pedometer securely to your clothing.Attaching the Leash: Attach the pedometer to the leash bylooping the leash around the pedometer belt clip. Next, claspthe waist-band of your clothing with the attached clip. You canalso use a safety pin to fasten the leash to your clothing, loopthe leash through your belt or belt loop or use a badge holder.OPERATING INSTRUCTIONSACCUSPLIT, Inc. • 2290M Ringwood Ave. • San Jose, CA 95131800-965-2008 • 925-226-0888 • FAX 925-463-0147 www.ACCUSPLIT.com • support@ACCUSPLIT.comACCUSPLIT®EAGLE™ 1120Eat Right! Walk More! Live Well! The ACCUSPLIT LifestyleCongratulations on taking the first step to wellness with your purchase of anACCUSPLIT pedometer. It’s easy to set up your new pedometer.Just follow the steps below, and start walking!RESETTING YOUR PEDOMETERMost people prefer to reset step counts daily. To \reset:Press and hold RESET button for at least three seconds toreset to zero.AUTO MOVEMENT SENSOR1. To filter out random movements, the unit remains in standbymode until 5 continuous steps are registered. Only then arethe 5 steps calculated in, and an Active indicator “▲”appears on the upper left of display.2. When regular walk/run movement stops, after 2 seconds thetimer pauses and the unit switches to standby status (Activeindicator “▲” disappears).REPLACING THE BATTERYWhen the display starts to dim or goes blank, it is time toreplace the battery. Your pedometer uses one Type L1142(LR43) 1.5 volt silver oxide battery. To replace:1. Using a jeweler’s screwdriver, loosen small screwon back of unit. Remove back of case.2. Slide the old battery gently out of its holder. Replace it witha new battery. The battery’s positive (+) terminal should beFACE UP while you put it into the pedometer.3. Gently press front and back of pedometer case backtogether, being sure to line up slots and tabs at top andbottom of unit.ACCUSPLITAccuSTEP10000.orgSTEPTW15MG1 1 2 0EAGLERESETVIEWING YOUR RESULTSOnce you put on your pedometer, it will automatically begin torecord your steps.970-042First, loop thepedometer clipNext, loop the metalclip, then clasp clothingOr, loop abadge holder, thenput into pocket(Badge holdernot included)Or, loop a belt or belt loopNO-PROOF-OF-PURCHASE LIMITED WARRANTYRefurbish, repair-or-replace service before 10/1/10, $5 fee; After 10/1/10,service may not be available. Return with fee and day phone # to:AST Repair Center/970-1010, 2290M Ringwood Ave., San Jose, CA 95131REGISTER NOW Please returnyour AE1120 Registration to theRepair Center address in thewarranty, and we will let youknow about future products.Email (preferred)User