4. How to UseUser Guide Page 4-74.1.4 Creating an ArrayWhen the RAID controller is first configured, an array needs to be set up. This array tellsthe controller how many disks to use and what their function should be.Follow the steps below to create an array:1. Select the RAID level from the drop down menu. Available levels are: 0, 1, 5, 6, 0+1and JBOD.NoteEach RAID level has a minimum disk requirement. This is shown inthe information to the right of the drop down list. For example,RAID 5 requires at least 3 drives.NoteDetails on the RAID levels are in Chapter 5 RAID Overview.2. Select the stripe size from the drop down menu. Available stripe sizes are: 8-256KB.The greater the stripe size, the faster the I/O output for each drive. This speeds updisk access.3. Select the sector size from the drop down menu. Available sector sizes are 512 bytes(default) and 4096 bytes. The sector size 4096 bytes is only supported by Windows XP,