Ace 3108685 User Manual

Ace 3108685 User Manual Manual pdf 1 page image

®© 2005 595-5753-053. Testing1. Installation2. AimingFigure 2 - Coverage Angles110°8 Ft.60 Ft.From HouseFigure 1 - Wiring at Junction Box PlateMotion SensingLightWhite to whiteBlack to blackConnect the fixture ground wireto the junction box ground wire.Specifications:Total Lighting Wattage .................Up to 150 Watts MaximumRange ...........................................Up to 60 ft.Time Delay ...................................1, 5, or 10 minutesReplacement lamp........................T3, Up to 150 Watt Maximumhalogen 120 VACCaution: This product is to be used with a U.L. listed rain tightor wet location suitable outlet box. Depending on the installation,additional hardware may be required.Note: Installation of this light control should be done only by thosewith experience in 120 Volt household wiring. Some local codesmay require that a licensed electrician install the light control.Model 3108685 / 3209574Caution: Always turn the circuit breaker off when wiringthe fixture.1. Remove the existing fixture.2. Knockout the mounting plate holes needed to mount the sensoron the junction box.3. Connect the light control as shown in Figure 1:• Black sensor wire to the black (HOT) house wire.• White sensor wire to the white (NEUTRAL) house wire.4. Attach the junction box cover plate to the junction box. Use aweatherproof sealant to seal the plate to the junction box.5. Adjust fixture. The lamp head should be at least 1 inch awayfrom the sensor.The sensor must be mounted below the lamp housing for wallinstallations.Caution: Do not mount the sensor above or touching the lamp(keep 1 inch or more from the lamp). The sensor bottom must befacing down for best coverage and to avoid water damage andelectrical shock.CAUTION: To Avoid Fire Or Burn Hazards:• Allow fixture to cool before touching. The bulb and the fixtureoperate at high temperatures.• Keep fixture at least 1" from combustible materials. Do not aimat objects closer than 3 ft.• Use only T3, 150 Watt (Maximum) tungsten halogen 120 VAClamps.Note: For under-eave installation, rotate the sensor head 180° bybending the sensor towards the clamp bracket. Rotate the sensorbottom clockwise away from the bracket.The coverage area for the sensor is shown in Figure 2. The sensorshould be aimed so that the motion to be detected is in front of andacross the coverage area. The sensor should be aimed looking outat a horizontal angle. To reduce false triggering, point the sensoraway from traffic areas, air conditioners, dryer vents, water pools,or anything which may move or change temperature rapidly.For motion sensing, put the ON-TIME switch on the bottom of thesensor in the 1, 5, or 10 minute position. When motion is detected,the lights will come on the selected time. Note: The photocell keepsthe lights from turning on in daylight.To keep lights on all night, flip the light switch off for 1 secondthen back on. Turning the light switch off for 1 second, then back onagain will return the control to the motion sensing mode. At dawn,the control will reset to the motion sensing mode and shut off.This light control automatically turns the light on when motion isdetected.4. OperationTurn the power back on at the circuit breaker. Turn the light switchon.Note: When first turned on wait about 1 1/2 minutes for the circuitryto calibrate.Put the TIME switch on the bottom of the sensor in the TEST position.You can now walk in front of the unit and the lights will come on forabout 5 seconds. The TEST mode works both day and night.Walk through the coverage area and point the sensor to obtain thedesired coverage area. Adjust sensitivity as needed.

/ 2

Related manuals for Ace 3108685