Ace ac-29 Owner's Manual

Ace ac-29 Owner's Manual Manual pdf 1 page image

© 2007 598-1225-01Installation Instructions and Drill Template.Read and Save these Instructions.• The non-electric chime mounts directlythrough the door and will accommodatedoor thicknesses of 3/4" to 2".• The chime is equipped with a viewer.Locating the door chime1. Mount the chime in the center of the doorapproximately 4 1/2 feet to 5 feet abovethe floor. Note: Be sure there are noobstructions on the inside of the doorto interfere with the chime’s baseplate.2. Using the template provided, mark thelocation of the mounting holes parallelto the edge of the door (see Figure 1).Note: It is important that the holes areparallel to the edge of the door for properoperation of the chime.3. Drill two 1" holes parallel to edge ofdoor.4. Drill three pilot holes using a 1/16" drillbit.Push button assembLySee Figure 1 for push button assembly.Note: If push button assembly is locatedin an area that is exposed to rain, caulkaround the 1” holes before attaching pushbutton to door.Figure 1 - Attaching Push Button Assembly to Doorattaching Push buttonassembLy1. Remove metal trim screw, metal trim,name card holder, and name card frompush button assembly to locate mountingholes (see Figure 1).2. Insert viewer and push button shaft intopredrilled until push button assembly isflush against door face. Attach using thethree mounting screws provided (seeFigure 1).3. Print or type name and address on namecard (provided). Place card in holderwith printing visible through front of cardholder.4. Place metal trim over push button as-sembly and name card holder. Securetrim with trim screw (see Figure 1).1/16" Pilot Hole1" Viewer Hole1" Shaft HoleViewerPush Button ShaftPush Button AssemblyMounting ScrewName CardName Card HolderMetal TrimDoor EdgeTrim ScrewTwo-NoteNon-Electric DoorChime – With ViewermodeL: ac-29