Chapter 4 - SCSISelect Configuration Utility 4-9Host Adapter SCSI TerminationThis option allows you to configure host controller SCSI termination. Figure 4-5shows the choices available if you have an AIC-7880. The default setting is LowOFF/High ON.Arrow keys to move cursor, to select option, to exit ( =default)Adaptec AIC7880 Ultra/Ultra W SCSISelect (TM) UtilityAIC-7880 Ultra/Ultra W at Bus:Device 01:06hConfigurationSCSI Bus Interface DefinitionsHost Adapter SCSI ID ................................ 7SCSI Parity Checking................................. EnabledHost Adapter SCSI Termination ................. EnabledAdditional OptionsBoot Device Options .................................. Press SCSI Device Configuration......................... Press Advanced Configuration Options................ Press - Reset to Host Adapter Defaults* EnabledDisabledFigure 4-5 Host Adapter SCSI Termination Selection for AIC-7880Use the cursor (↑ ↓) and Enter keys to make your selection.Since the system contains both UltraWide (68-pin) SCSI devices and narrow (50-pin) SCSIdevices, termination must be set to allow eachsection of the SCSI bus to be terminated. Thenarrow device in this system is terminated,causing the LOW byte on the motherboard to beturned off. On the other end, the back panelterminates both bytes (Low OFF/High ON).
