iiiNoticesFCC noticeClass A devices do not have an FCC logo or FCC IDE on the label. Class B deviceshave an FCC logo or FCC IDE on the label. Once the class of the device isdetermined, refer to the following corresponding statement.Class A equipmentThis device has been tested and found to comply with the limits for a Class Adigital device pursuant to Part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference when theequipment is operated in a commercial environment. This equipmentgenerates, uses, and can radiate radio frequency energy, and if not installedand used in accordance with the instructions, may cause harmful interference toradio communications. Operation of this equipment in a residential area islikely to cause harmful interference, in which case the user will be required tocorrect the interference at personal expense.Class B equipmentThis device has been tested and found to comply with the limits for a Class Bdigital device pursuant to Part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference in a residentialinstallation. This device generates, uses, and can radiate radio frequencyenergy, and if not installed and used in accordance with the instructions, maycause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this device does cause harmful interference to radio or televisionreception, which can be determined by turning the device off and on, the useris encouraged to try to correct the interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna• Increase the separation between the device and receiver• Connect the device into an outlet on a circuit different from that to whichthe receiver is connected• Consult the dealer or an experienced radio/television technician for help