51 Altos R720 Installation Configuration GuideDevice Version EasyBUILD VersionIntegrated SAShardware RAID 2 00.00.03.18 EasyBUILD 8.0 build 200 (or later)Onboard Chipset N/A OS built-inOnboard GigabitEthernet 0.3.3.3 EasyBUILD 8.0 build 200 (or later)Onboard VGA N/A OS built-inOnboard USB 2.0 N/A OS built-inIOAT 2.15 EasyBUILD 8.0 build 200 (or later)Software RequiredThe management utility of integrated SAS hardware RAID 2 can be found inthe EasyBUILD.Software Version EasyBUILD VersionRAID Web Console2 2.63 EasyBUILD 8.0 build 200 (or later)Configuring integrated SAS hardware RAID 2Please refer to the APPENDIX B. for the integrated SAS hardware RAID 2configuration.Installation TipsNOTE. There is no built-in driver for Integrated SAS hardware RAID 2 in the RedHat Enterprise Linux 5.0. If you do not have the optional internal USB floppydrive, you need an external USB floppy drive for applying driver during the OSinstallation.1. Since Red Hat Enterprise Linux 5.0 cannot recognize the integrated SAShardware RAID 2, you need to make a driver diskette from the EasyBUILDfirst before the installation.2. Type linux dd when the prompt boot: appears at the start.3. Please select the sda as the Driver Disk Source.4. Follow the instruction to load the integrated SAS hardware RAID 2 driverfrom the driver diskette.5. At the package selection step, select Software Development for theinstallation package.6. Please follow the normal procedure to finish the installation.Gigabit Ethernet Driver InstallationNOTE. Please install the kernel-devel- package with the CD #1 ofRed Hat Enterprise Linux 5 prior to install the Gigabit Ethernet driver.1. You can find the Gigabit Ethernet driver in EasyBUILD. Please copy the
