38 TravelMate 230/ 280Main System SettingsThe Basic System Settings screen allows you to set the system date and time.The following table describes the parameters in this screen.Parameter Description FormatSystem Time Sets the system time. HH:MM:SS (hour:minute:second)System Date Sets the system date. DDD MMM DD, YYYY(day-of-the-week month day, year)Boot Display Sets the display device on boot up.When set to Auto, the computerautomatically determines thedisplay device. If an externaldisplay device (e.g., monitor) isconnected, it becomes the bootdisplay. When set to Both, thecomputer outputs to both thecomputer display screen and anexternal display device if one isconnected.Auto or BothQuick Boot Mode Allow the system to skip certaintests while booting. This willdecrease the time needed to bootthe system.Enabled or DisabledBoot-time DiagnosticScreenBoot-time diagnostic during boot.Help: Enable to show the BIOS logopicture screen on boot up.Disabled or EnabledPhoenixBIOS Setup UtilityInformation Main Advanced Security Boot ExitSystem Time:System Date:Boot DisplayQuickBoot ModeBoot-time Diagnostic Screen:Boot on LANHotkey BeepAuto DimF12 Multi-Boot[08:46:55][12/03/2002][Auto][Enabled][Disabled][Disabled][Enabled][Enabled][Enabled]Item Specific Help, , or selects field.F1 Help ÏÐ Select Item F5/F6 Change Values F9 Setup DefaultsEsc Exit ÍÎ Select Menu Enter Select > Sub-Menu F10 Save and ExitPhoenixBIOS Setup UtilityPhoenixBIOS Setup UtilityInformation Main Advanced Security Boot ExitInformation Main Advanced Security Boot ExitSystem Time:System Date:Boot DisplayQuickBoot ModeBoot-time Diagnostic Screen:Boot on LANHotkey BeepAuto DimF12 Multi-BootSystem Time:System Date:Boot DisplayQuickBoot ModeBoot-time Diagnostic Screen:Boot on LANHotkey BeepAuto DimF12 Multi-Boot[08:46:55][12/03/2002][Auto][Enabled][Disabled][Disabled][Enabled][Enabled][Enabled][08:46:55][12/03/2002][Auto][Enabled][Disabled][Disabled][Enabled][Enabled][Enabled]Item Specific HelpItem Specific Help, , or selects field., , or selects field.F1 Help ÏÐ Select Item F5/F6 Change Values F9 Setup DefaultsEsc Exit ÍÎ Select Menu Enter Select > Sub-Menu F10 Save and ExitF1 Help ÏÐ Select Item F5/F6 Change Values F9 Setup DefaultsEsc Exit ÍÎ Select Menu Enter Select > Sub-Menu F10 Save and Exit