1 – SAFETY INSTRUCTIONSWarning: Before using your M INI L.E.D.,please read the whole of this SafetyInstructions section carefully. Themanufacturer’s warranty is applicable only if theseinstructions concerning the operation and the safety ofthe unit have been properly applied. All these safetymeasures assume a good level of knowledge of dentaltechniques and photo-polymerization, and the morespecific knowledge regarding the use of the M INI L.E.D.contained in this Operating Manual.1) This unit must be used in strict accordance with theinstructions contained in this Operating Manual. Themanufacturer declines any liability if these rules arenot followed or if the unit is used for any otherapplication.2) Before connecting the unit, make sure that the powervoltage is compatible with the voltage marked on thepower adapter used to charge the curing light. Adifferent voltage would damage the unit and couldresult in injury to the patient and/or the operator.3) The light radiation produced by this type of unit canbe dangerous and must not be pointed at the eyes,even if the practitioner or the patient is wearingsuitable protective eyewear (class 2M laser). Thelight produced by this equipment must be directedonly at the zone to be treated in the oral cavity.4) Any condensation inside electrical equipment can bea hazard. If the curing light has to be moved from acool place to a warm place, do not use itimmediately: let it reach the new room temperaturefirst.5) Do not replace the battery during use.6) Comply with all the instructions given in this Manual.Do not insert or attempt to insert metal objects intothe unit or its base station, as this could cause anelectrical discharge.7) The manufacturer declines all liability if damagedparts or accessories are not replaced exclusively bythe manufacturer’s products. In particular, the use ofother light guides, power adapters or batteries couldbe dangerous for the patient and the operator.8) In the case of a fault, unplug the base stationimmediately and make sure that no one can use thecuring light before it is checked by the manufactureror dealer. The fault may be the result of non-compliance with the safety rules or of a technicalproblem in the unit.9) Do not use the unit near a heat source. Do not usesolvents, detergents or flammable products, whichmay damage the unit or cause short-circuits.10) Only the unit manufacturer or dealer is qualified tocarry out repairs.11) All lights used for photo-polymerization, includingthe M INI L.E.D., must not be used on persons whoare suffering or have suffered from photo-biologicalreactions (including urticaria solaris orerythropoeitic protoporphyria) or who are receivingtreatment including photosensitizing medications(including methoxsalens or chlorotetracycline).12) Persons (practitioners or patients) who havepreviously suffered from a retina or crystalline lenscondition or who have undergone eye surgery, inparticular for cataracts, must see theirophthalmologist before using the M INI L.E.D.. Even ifthe eye specialist agrees, prudence is stronglyrecommended, because the intensity of the lightcould cause accidents. Class 2M protective eyewear,suitable for use with units emitting radiation atwavelengths between 420 and 480 nm, should beworn at all times.13) M INI L.E.D. must not be used if the patient and/orthe operator has a cardiac stimulator or any otheractive implant (e.g. a cochlear implant).14) The device is not designed to withstand shocksdelivered by an electric defibrillator.15) Any variation of the power supply voltage or themagnetic field outside the limits in force couldswitch the curing light to automatic operation orinterfere with its operation.16) Electromagnetic interference: the unit complies withthe applicable standards (IEC 60 601-1-2) for emission(radiated electrical field and interference with thesupply voltage) and for immunity (protection againstelectrical fields, fast supply transients in bursts,electrostatic discharge and supply surges).17) Your dealer carries stocks of all spare parts that youmight need. Used batteries must be returned to thedealer.4