ActronAir Serene WRC-026AS Installation Manual

Page 12Step 4: Prepare refrigerant pipingThe refrigerant piping is inside an insulating sleeve attachedto the back of the unit. You must prepare the pipingbefore passing it through the hole in the wall. Refer to theRefrigerant Piping Connection section of this manualfor detailed instructions on pipe flaring and flare torquerequirements, technique, etc.NOTE ON PIPING ANGLERefrigerant piping can exit the indoor unit from fourdifferent angles:• Left-hand side• Left rear• Right-hand side• Right rearRefer to Fig. 4.4 for details. Move to left or right30-50mm30-50mmFig. 5.4CAUTIONBe extremely careful not to dent or damagethe piping while bending them away from theunit. Any dents in the piping will affect the unit’sperformance.If refrigerant piping is already embedded in the wall,do the following:Step 1: Hook the indoor unit on the mounting plate:Keep in mind that the hooks on the mounting plate aresmaller than the holes on the back of the unit. If you findthat you don’t have ample room to connect embeddedpipes to the indoor unit, the unit can be adjusted left orright by about 30-50mm, depending on the model.(See Fig.5.5)Move to left or right30-50mm30-50mmFig. 5.5Step 2: Prepare refrigerant piping:1. Disassemble the louvre:Move to left or right30-50mm30-50mmFig. 5.62. Open and fix the position of the panel firstly, unscrewthe two screws showed in the picture below, then openthe panel, and fix the position of the panel by the latch(see Fig.5.7).5. Indoor Unit Installation Serene Wall Hung Split SystemInstallation Overview