Chapter 3: System Setup3. Slide the Panel PC through the hole until it is properly fitted against thepanel.4. Position the mounting clamps along the rear edges of the Panel PC. Thefirst and second clamps must be positioned and secured diagonally priorto mounting the rest of the clamps. Tighten the clamp's screw until ittouches the panel.ClampPanelCAUTION! Do not overtighten the screws to prevent damaging thePanel PC.60Panel Mounting1. Select a place on the panel where you will mount the Panel PC.2. Cut out a shape on the panel that corresponds to the Panel PC's reardimensions.The thickness of the panel (e.g. steel board, plank, acrylic board, wall, etc.)where you will mount the Panel PC must not exceed 6mm. If the distancebetween the front bezel and panel mount hole is too wide, it will not fit the panelmount kit.371.006mm297.00AcuPanel 15
