3-9Installing the Driver3 Turn on the computer, then insert the driver disk.4 To run the pkgadd utility, type pkgadd -d diskette1 and thenpress Enter. UNIX reads the disk and package information.5 Press Enter.6 Restart the computer. The system rebuilds the kernelautomatically.7 Add devices created on the RAID controller to the operatingsystem. For details, refer to your OpenServer documentation.Installing the NetWare DriverThis section contains the following procedures:■ Installing the Driver When You Install NetWare on page 3-9■ Installing the Driver in an Existing NetWare System on page 3-10■ Loading NetWare Drivers During Server Restart on page 3-11Installing the Driver When You Install NetWareTo install the driver with the operating system during a freshinstall:1 Install and configure the controller and hard drives, asdescribed in page 2-3.2 Create the bootable array, as described on page 2-5.3 Create the driver disk, as described on page 3-2. When finished,remove the driver disk.4 Restart the computer, then press Ctrl+A when prompted to accessthe ARC utility. Use ARC to create the RAID. For details, seeUsing the Adaptec RAID Configuration (ARC) Utility on page 2-6.5 Install and configure a secondary controller, if any.6 Create the driver disk, as described on page 3-2. When finished,remove the driver disk.7 Install the operating system according to the NetWaredocumentation. Verify that you have the aacraid.ham andaacraid.ddi files available on the driver disk created at thebeginning of this chapter.
