Chapter 8: Installing the Driver on an Existing Operating System ● 55Installing on OpenServerTo install the driver on OpenServer:1 Start your computer, then insert the driver disk.2 Begin the driver package installer:pkgadd -d diskette13 At the installer prompt, type go.4 Select 1 for the aacraid package.5 When the installation is complete, select q to quit the installer.6 Reboot your computer and remove the driver disk.7 Continue with Managing Your Storage Space on page 57.Installing on UnixWareTo install the driver on UnixWare:1 Start your computer, then insert the driver disk.2 Begin the driver package installer:pkgadd -d diskette13 At the installer prompt, type go.4 Select 1 for the aacraid package.5 When the installation is complete, select q to quit the installer.6 Reboot your computer and remove the driver disk.7 Continue with Managing Your Storage Space on page 57.Installing on SolarisTo install the driver on Solaris:1 Start your computer.2 Check for any pre-existing Adaptec driver by performing a pkginfo SUNWaac in a terminalwindow. If there is no pre-existing Adaptec driver on your computer, continue withStep 3. If an Adaptec driver is already installed on your computer, perform a pkgrmSUNWaac to remove it.Caution: If your operating system currently boots from the Adaptec controller, do notreset your computer after you remove the pre-existing Adaptec driver. Instead, followthe steps in this section to install a new driver before rebooting your computer.3 Insert and mount the driver disk:volcheck4 Change to the driver installer directory:cd /floppy/floppy0/DU/sol_210/i86pc/Tools!
