12Regulatory Compliance StatementsFederal Communications Commission Radio Frequency Interference StatementWARNING: Changes or modifications to this unit not expressly approved by the partyresponsible for compliance could void the user’s authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. This equipment generates, uses, andcan radiate radio frequency energy, and if not installed and used in accordance with theinstruction manual, may cause harmful interference to radio communications. However, there isno guarantee that interference will not occur in a particular installation. However, if thisequipment does cause interference to radio or television equipment reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between equipment and receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver isconnected. Consult the dealer or an experienced radio/television technician for help. Use a shielded and properly grounded I/O cable and power cable to ensure compliance ofthis unit to the specified limits of the rules.This device complies with part 15 of the FCC rules. Operation is subject to the following twoconditions: (1) this device may not cause harmful interference and (2) this device must acceptany interference received, including interference that may cause undesired operation.European Union Compliance StatementThis Information Technology Equipment has been tested and found to comply withEMC Directive 89/336/EEC, as amended by 92/31/EEC and 93/68/EEC, inaccordance with: EN55022 (1998) Emissions EN55024 (1998) Immunity:– EN61000-4-2 (1998) Electrostatic discharge: ±4 kV contact, ±8 kV air– EN61000-4-3 (1998) Radiated immunity– EN61000-4-4 (1995) Electrical fast transients/burst: ±1 kV AC, ±0.5 kV I/O– EN61000-4-5 (1995) Surges ±1 kV differential mode, ±2 kV common mode– EN61000-4-6 (1996) Conducted immunity: 3 V– EN61000-4-11 (1994) Supply dips and variation: 30% and 100%In addition, all equipment requiring U.L. listing has been found to comply with EMCDirective 73/23/EEC as amended by 93/68/EEC in accordance with EN60950 withamendments A1, A2, A3, A4, A11.Australian/New Zealand Compliance StatementThis device has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to the Australian/New Zealand standard AS/NZS 3548 set out bythe Spectrum Management Agency.Adaptec, Inc. Adaptec SCSITested to ComplyWith FCC StandardsFOR HOME OR OFFICE USECard 29320A