Adaptec 29320A Installation Manual

Also see for 29320A: Manual Installation guide

Contents

troubleshooting

3Computers may have vertical or horizontal expansion slots.Refer to your computer manual to locate the PCI/PCI-X slots. Ifyour computer is a tower model, lay it on its side to allow foreasier installation of the Adaptec SCSI Card 29320A.Warning: Be careful when inserting the Adaptec SCSI Card29320A in a PCI slot. Some 32-bit slots will notaccommodate it, and the card may break if you force it intothe slot.4 Insert the Adaptec SCSI Card 29320A in the 64-bit (or 32-bit)PCI or PCI-X expansion slot; press down firmly until the cardclicks into place, then replace the slot cover screw. Wheninstalled properly, the card should appear level with theexpansion slot, as shown below.Setting Up SCSI DevicesThere are several things you may need to do to your SCSI devicesbefore you connect them to the Adaptec SCSI Card 29320A: Check the SCSI IDs Set the termination Connect the power cablesSince setup can vary from device to device, always refer to thedevice’s documentation for specific instructions.