10Preloaded Adaptec DriversIf the Adaptec SCSI Card 39320D was included as part of acomputer system you purchased, the system already has theappropriate Adaptec driver preinstalled by the computermanufacturer. No further action is necessary to install the driver.Embedded Adaptec DriversSome operating systems have embedded driver support for theAdaptec SCSI Card 39320D. To determine if the card is supportedby the operating system you are using, read the operating systemmanual or contact the operating system vendor for information.ADAPTEC SCSI C ARD D RIVER S OFTWARETo use the Adaptec SCSI Card 39320D, driver softwaremust be installed for your operating system. Installation of thedriver software varies depending on how and where youpurchased the Adaptec SCSI Card 39320D.NOTE

connecting external scsi devices

Adaptec 39320D-R Manual

Ultra320 SCSI on the Adaptec SCSI Card 39320D

Device Drivers

System Requirements

SCSI IDs

Terminating the SCSI Bus

Using SCSI Devices

Combining SCSI and Non-SCSI Devices

Installing Multiple SCSI Cards

Connecting the LED Connector

Overriding SCSI Termination Settings

Connecting SCSI Devices

Maximum Cable Lengths

Starting SCSISelect

Using SCSISelect Settings

Boot Device Configuration – Non-BBS Systems Only

Advanced Configuration Options

Changing Configuration Settings

scsi device configuration

Using SCSI Disk Utilities

Verifying or Formatting a Disk

Installing the Driver When Installing Windows 2000

Updating the Driver When Windows 2000 is Already Installed

Upgrading a Windows NT 4.0 Installation to Windows 2000

Using Driver-specific Parameters

Installing a New Host Adapter after Windows 2000 Is Already Installed

Swapping a Host Adapter

Troubleshooting

Error Messages

Driver Error Messages

Installing Windows NT

Installing the Driver When Installing Windows NT

Completing a Fresh Windows NT 4.0 Installation From CD

Installing the Driver When Windows NT 4.0 is Already Installed

Using Advanced Configuration Parameters

Hot-Plug PCI Support

Using Windows NT 4.0 and the Host Adapter

Problems and Solutions

adpu320.sys Error Messages

Installing the Driver When Installing Windows XP

Installing Windows XP (64-bit)

Installing a New Host Adapter after Windows XP is Already Installed

Using Windows XP SCSI Parameters

Removing a Host Adapter

installing novell netware

Installing the Driver When Installing NetWare

NetWare 5.0

Installing the Driver When NetWare is Already Installed

Loading the Driver at Server Bootup

Using the Load Command Line Options

Bit Mask Options

Using NetWare and the Host Adapter

Mount Status

Using a CD with NetWare

NetWare 5.x and 6.0

Installing the Driver When UnixWare/Open Unix is Already Installed

Back Up the Kernel

Modify the New System File

Boot the New Kernel

Using UnixWare/Open Unix and the Host Adapter

Removing the Driver

Installing the driver when installing Solaris 8

Installing the Driver when Solaris 8 is Already Installed

Removing the Driver From Solaris 8

Command Line Options

Installing the Device Drivers for Red Hat Linux

Installing the Device Drivers for SuSE Linux

Troubleshooting Checklist

General Troubleshooting

Troubleshooting in Windows NT 4.0

39320D

39320D-R