Adaptec ARO-1130U2 Installation And Hardware Manual

Contents

C-2ARO-1130U2 Installation and Hardware GuideWindows NT TroubleshootingError Messages While Setting Up Windows NT“Setup is unable to locate the hard drive partition prepared by theMS-DOS portion of setup”or“xxxx MB disk y at Id z on bus 0 on cda1000.sys does not contain apartition suitable for starting Window NT”If these messages appear during Windows NT setup, do thefollowing:1 Re-boot the server using the ArrayConfigU2 diskette.2 Run the ArrayConfigU2 Utility to ensure that the boot arrayincludes the drive with the lowest SCSI target ID.“Boot: Couldn't find NTLDR”If this message appears when attempting to boot from the WindowsNT installation CD, boot from the Windows NT installation floppydiskettes instead, and proceed to load Windows NT from the CD-ROM.“No Accessible Boot Device”When attempting to boot from the Windows NT installation CD, thismessage indicates that the NT CD-ROM does not containArray1000U2 drivers. To avoid this failure, try the following:1 Reboot the Windows NT installation CD.2 When the prompt “Setup is inspecting your computer system'shardware” appears, press the F6 key repeatedly.3 Windows NT will later prompt you for the Array1000U2 driverdiskette and the installation should continue as normal.