7FCC Compliance StatementNOTE: This equipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of the FCC rules. These lim-its are designed to provide reasonable protection against harmful interfer-ence in residential installations. This equipment generates, uses, and canradiate radio frequency energy, and if not installed and used in accordancewith the instructions, may cause harmful interference to radio communica-tions. However, there is no guarantee that interference will not occur in aparticular installation.If this equipment does cause interference to radio or television equipmentreception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the receiving antenna.• Move the equipment away from the receiver.• Plug the equipment into an outlet on a circuit different from used by thereceiver.• If necessary, consult the dealer or an experienced radio/television tech-nician for additional suggestions.Finally, any changes or modifications to the equipment by the user notexpressly approved by the grantee or manufacturer could void the user'sauthority to operate such equipment.This device complies with part 15 of the FCC rules. Operation is subject tothe following two conditions: (1) this device may not cause harmful interfer-ence and (2) this device must accept any interference received, includinginterference that may cause undesired operation.Adaptec, Inc.691 South Milpitas Blvd.Milpitas, CA 95035Copyright © 1994, Adaptec, Inc. All rights reserved. Adaptec, theAdaptec logo, and APA are trademarks of Adaptec, Inc. whichmay be registered in some jurisdictions. All other trademarksused are owned by their respective owners.Printed in SingaporeStock No.: 510691-00, Rev. A CV 10/94Information subject to change without notice.