Chapter 7: Installing the Driver and an Operating System l 45Installing with NetWareNote: NetWare does not support drive enclosures with port multipliers but supports eSATA drives.You will need your NetWare Installation CD to complete this task. To install the driver wheninstalling NetWare:1 Restart your computer, then install NetWare. (For instructions, refer to your NetWaredocumentation.)To be able to load additional drivers later, select Manual install mode during the first partof the installation.2 Click Continue to load additional drivers:a Select Modify when the storage adapters are displayed.b Select Storage Adapters, then press the Insert key twice to add an unlisted driver fromthe floppy disk.3 When the Device Types screen displays, check the Storage adapters list, then select Modifyto add another driver.4 Select Storage Adapters, then press Enter.All recognized controllers are displayed.5 If necessary, remove the default HostRAID driver (<driver-name>.ham).6 Press the Delete key to remove it.7 Press Insert to add another driver.The available drivers are displayed.8 Insert the driver floppy disk.9 Press the Insert key to scan the floppy disk drive.Once the driver is selected, the Parameter screen is displayed.10 From the lower window menu, select Continue, then press Enter.If the driver installation process fails, the server console is displayed so you can see thecause of the failure.To modify disk partitions, apply hot fixes, or perform volume maintenance, refer to yourNetWare documentation.11 Continue with Managing Your Storage Space on page 50.