Adaptec RAID 2120S Installation Manual

Also see for 2120S - SCSI RAID Controller: User guide Installation guide Installation guide Installation and user guide Software reference guide

Contents

Adaptec RAID 2120S Installation Manual Manual pdf 50 page image

3-19Installing the Driver5 To run the installpkg utility, type installpkg -d disk/.SCO UNIX reads the disk and prompts you to enter the packagename to be installed.6 Type aacraid_tar.z and press Return.7 After the package is installed, rebuild the kernel.8 Restart the system.9 Install the new kernel.10 Add devices to the controller.UnixWare 7 and OpenUNIX 8Both UnixWare 7 and OpenUNIX 8 use the same procedures foradding the driver to the system, whether an initial installation orjust adding to an existing system. The driver disk you create will bespecific to one operating system or the other. Once the driver diskis created, there is no difference in the installation.Installing the Driver on a New SystemIn this scenario, you are installing the controller and driver for asystem on which either OpenUNIX 8 or UNIXWare 7 is beinginstalled as the operating system. The operating system will beinstalled on an Adaptec RAID controller-based RAID.To install the driver:1 Install and configure your Adaptec controller and hard diskdrives according to the instructions in Chapter 2.2 Create the driver disk as shown at the beginning of this chapter.3 Early in the operating system installation, you will be shown awindow labeled Choose One, insert the driver disk, select theInstall HBA diskette entry, then press F10. The driver will loadfrom the driver disk and return to the HBA screen. SelectProceed with Installation and press F10.4 Complete the installation as appropriate.5 When the installation completes, remove the driver disk andreboot the system.The boot driver installation process is complete.