Adaptec Snap Server 700i Series Service Manual
Also see for Snap Server 700i Series: DatasheetUser guide
                           | |
Replacing a Power Supply Module Snap Server 700i Series2 Field Service DocumentationCopyright © 2007, Adaptec, Inc. All rights reserved. Information in this document is subject to change without notice and does not representa commitment on the part of Adaptec or any of its subsidiaries.3 To release the module, pull the handle up, push the red latch to the right, andthen pull the handle towards you.4 Grasp the handle and pull the module out of the chassis, catching the body of themodule in the other hand, and set it aside.Inserting a Replacement Power Supply Module1 Resting the body of the module in one hand while holding the handle with theother, insert the module and slide firmly into place. Make sure it is seated all theway into the chassis.2 The latch will lock the module into place. Fold the handle down against themodule.3 Insert the power cord and connect to a power source. The LED should be solidgreen.Note If you have a dual power supply and do not immediately insert the powercord and connect it to a power source, an alarm will sound until you do.Release latch |
Related manuals for Adaptec Snap Server 700i Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine