Adaptec USB2Xchange User Manual
                                        | |
Contents
|
5Installing USB2Xchange5 Connect other devices by cabling each device to the previousone, as shown in the figure on page 5.6 Terminate the last device in the SCSI chain, as shown in thefigure below. All other devices must have termination set todisabled. See Terminating the SCSI Bus on page 25, for moreinformation.7 Power on your SCSI devices.Connecting to Your ComputerTo connect your USB2Xchange adapter to your computer:1 Power on your computer.2 Plug the USB connector into the USB port on your computer.3 Make sure the cable ends are firmly connected. Do not force yourconnections as this may damage your system or the USB2Xchange.Note: The USB2Xchange receives its +5V power from eitherthe terminator power line of the attached SCSI device, or ifno termination power is available, from the USB bus.Terminated deviceUnterminated devicesUSB2Xchange adapter |
Related manuals for Adaptec USB2Xchange
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine