Adeunis RF WMBUS ANALOG PWR ARF8201CA User Manual

Contents

Adeunis RF WMBUS ANALOG PWR ARF8201CA User Manual Manual pdf 59 page image

ENWMBUS ANALOG PWR - Guide utilisateur / User guide version V2.0.159Page of 83FR2.2.5 TEST ModeThis mode allows the user to perform tests of the product more quickly by reducing the time scales of the production mode and modifying thebehavior of the LEDs.It is obtained by positioning register S306 at the value 2 in the COMMAND mode. Once out of the command mode, the product returns to thepreviously defined application behavior but with the following changes:- Register S300: the periodicity of the Keep Alive frame is expressed in groups of twenty seconds instead of tens of minutes. Hence intest mode when register 300 = 144, the Keep Alive frame is no longer sent every 144x10min=1440 minutes or 24h but every 144x20s=2880seconds or 48 minutes.- Register S301: the periodicity of the sending of data (periodic mode) is expressed in groups of twenty seconds instead of tens ofminutes. Hence in test mode when register 301 = 1, the data frame is no longer sent every 10min but every 20 seconds.- In the event mode with transmission on threshold overrun the monitoring period of inspection by the sensors, normally 10 minutesis now, in TEST mode, set to 100 seconds.-The LEDS also have different behavior, allowing a visual feedback to the user in the event of transmission and reception of frames(see paragraph 2.3 for more details).A complete list of the registers can be found in paragraph 3.4.E.g.:Register Value encoding Value ResultS306 Decimal 2 The product is in TEST modeS300 Decimal 72 The Keep Alive frame is sent every: 72x20=1440s= 24 minutesS301 Decimal 6 Periodic mode with a period of 6x20 = 120s = 2minutes2.3. Operation of the LEDsMode LED red state LED green stateTransmission of frame (TEST mode only) ON during the transmission cycleReception of frame (TEST mode only) ON during the reception of a downlink frameProduct in Park mode OFF OFFMagnet detection process (1 to 6 seconds) OFF ON from detection of the magnet up to amaximum of 1 secondProduct start (after detection of the magnet) OFF Rapid flashing 6 cycles, 100 ms ON / 100ms OFFSwitching to the Command mode Continuously lit Continuously litBattery level low Flashing (0.5s ON every 60s)Product faulty (return to factory) Fixed ONProduct in production mode (TEST modeonly)50ms ON / 30 s OFF 50ms ON / 30 s OFF (just before the redLED)Product in REPLI mode Flashing (100ms ON / 100ms OFF) x 2 every 5s