SERVICE MANUAL ENGLISHRS 501 33019746(2)2010-03 59IMPIANTO FRENIPARKING BRAKE CONTROL CABLE REPLACEMENTEmpty the hopper (3); if it contains a small quantity of waste, it is not necessary to dump it.1.Drive the machine on a solid and level ground, then engage the parking brake with the lever (66).2.Lift the hopper (3), according to the procedure shown in the Instructions for use Manual.3.Turn the ignition key (76) to OFF position and remove it.4.Open the left door (18) by releasing the fasteners (19) with the supplied key.5.Remove the locking pins (28) from the housings (29) and place them into the holes (30).6.Empty the dust control system water tanks (7 and 16) according to the procedure shown in the relevant paragraph.7.Remove the screw (42) and open the left tank (41).8.WARNING!Open the tanks (7 and 16) only if they are empty: Each tank contains 264.5 lb (120 kg) of water approximately.Operating under the parking brake lever (66), unscrew the locknuts (C) and (D), disconnect the control cable (E) or (B) and9.recover the relevant spring (A).Remove the front wheel (see the procedure in the relevant paragraph).10.Place safety stands under the machine side sill.11.Remove the screw (H) and the screws (I), then remove the washer (J).12.Through the hole (F), turn the inner roller so that the shoes withdraw. When the shows are withdrawn, the drum can turn freely.13.Place the puller (G) on the drum (K) and match the puller holes with the drum columns (Q).14.Fasten the puller (G) with the wheel mounting nuts (R).15.Remove the drum (K) by slightly hammering the screw (S).16.Remove the three springs (L).17.Remove the shoe retaining springs (M).18.Remove the shoes (N) by disengaging the parking brake control cable (O) from the lever (P).19.Perform steps 3 to 6 and 8 to 19 in the reverse order.20.Adjust the parking brake (see the procedure in the relevant paragraph).21.If necessary, fill the dust control system water tanks according to the procedure shown in the Instructions for use Manual.22.BEADCS341022
