SERVICE MANUAL ENGLISHRS 501 33019746(2)2010-03 61IMPIANTO FRENIBRAKE SYSTEM CHECKCheck the brake fluid level (see the procedure in the relevant paragraph).1.Press the brake pedal (57) several times, and check that brakes operate properly.2.Check that there are no leaks from the brake system.3.If necessary, check/replace the brakes (see the procedure in relevant paragraph).4.If necessary, bleed the brake system (see the procedure in the relevant paragraph).5.BRAKING MASSES REPLACEMENTRemove the front wheel (see the procedure in the relevant paragraph).1.Place safety stands under the machine side sill, on the side where the wheel has been removed.2.Remove the screw (A) and the screws (B), then remove the washer (C).3.Through the hole (J), turn the inner roller so that the shoes withdraw. When the shows are withdrawn, the drum can turn freely.4.Place the puller (L) on the drum (D) and match the puller holes with the drum columns (K).5.Fasten the puller (L) with the wheel mounting nuts (M).6.Remove the drum (D) by slightly hammering the screw (N).7.Remove the three springs (E).8.Remove the shoe retaining springs (F).9.Remove the shoes (G) together with the braking masses, by disengaging the parking brake control cable (H) from the lever (I).10.Perform steps 1 to 10 in the reverse order.11.JLCA BDMNKEIFGE EGFHKS341023
