Chapter 3 Software Configuration 373.5 Ethernet interface configurationThe PCM-5820 Series' on-board Ethernet interface supports all majornetwork operating systems. To configure the medium type, to viewthe current configuration, or to run diagnostics, do the following:1. Power the PCM-5820 Series on. Make sure that theRSET8139.EXE file is located in the working drive.2. At the prompt, type RSET8139.EXE and press . TheEthernet configuration program will then be displayed.3. This simple screen shows all the available options for the Ethernetinterface. Just highlight the option you wish to change by using theUp and Down keys. To change a selected item, press , anda screen will appear with the available options. Highlight youroption and press . Each highlighted option has a helpfulmessage guide displayed at the bottom of the screen for additionalinformation.4. After you have made your selections and are sure this is theconfiguration you want, press ESC. A prompt will appear asking ifyou want to save the configuration. Press Y if you want to save.The Ethernet Setup Menu also offers three very useful diagnosticfunctions. These are:1. Run EEPROM test2. Run Diagnostics on Board3. Run Diagnostics on NetworkEach option has its own display screen that shows the format andresult of any diagnostic tests undertaken.
