Chapter 3 Software Configuration 333.3 VGA display software configurationThe PCM-5823 on-board VGA/LCD interface supports an 18-bit TFTLCD, flat panel displays and traditional analog CRT monitors. Theinterface can drive CRT displays with resolutions up to 1024 x 768 in16 bpp. It is also capable of driving color panel displays with resolu-tions of 1024 x 768 in 18 bpp. The LCD type is configured complete-ly via the software utility, so you do not have to set any jumpers.Configure the LCD type as follows:1. Apply power to the PCM-5823 Series with a color TFT displayattached. This is the default setting for the PCM-5823 Series.Make sure that the AWDFLASH.EXE and *.BIN files are locatedin the working drive.Note: Make sure that you do not run AWDFLASH.EXEwhile your system is operating in EMM386 mode.2. At the prompt, type AWDFLASH.EXE and press . TheVGA configuration program will then display the following:Figure 3-2: BIOS VGA setup screenArtisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
