Advent AMM10N Installation And Operation Manual

Advent AMM10N Installation And Operation Manual Manual pdf 16 page image

12AMM10NUSING THE TFT MONITOROpen/Close TFT MonitorOpen TFT MonitorPress the OPEN button (1) on the front panel or press the( ) button (25) on the remote control to activate themechanism that moves the display panel into the viewingposition.Close TFT MonitorPress the OPEN button (1) on the front panel or press the( ) button (25) on the remote control to load the displaypanel back into the compartment.TFT Monitor Auto OpenIf “TFT Auto Open” is “on” when the unit is turned on, themonitor automatically moves to the viewing position.If “TFT Auto Open” is ”off” when the unit is turned on, pressthe OPEN button (1) or ( ) button (25) on the remotecontrol to move the monitor into the viewing position.If “TFT Auto Open” is set to ”Manual”, the TFT will not closewhen the key is turned off.Monitor Tilt Angle AdjustmentA known characteristic of LCD panels is the quality of thedisplay in relationship to the viewing angle. The monitorangle can be adjusted for optimum viewing using one of thefollowing methods.Step by Step Angle AdjustmentPress the ( ) or ( ) button on the control panel (23, 24) orremote control (26, 27) to adjust the tilt angle of the screenone step at a time.Continuous Angle AdjustmentPress and hold the ( ) or ( ) button on the control panelor remote control to adjust the tilt angle in a continuousmotion.Monitor Left/Right Angle AdjustmentTo manually adjust the left/right angle of the TFT screen,follow these steps:1. Make sure the TFT screen in “Out”. Press the OPENbutton (1), if necessary.2. Locate the extender mechanism behind the screen.3. Firmly grasp both sides of the screen near the bottom.4. Gently pull on either the left or right side until theextender mechanism becomes fully extended.Reverse Driving UseIf the rear-view video camera is connected, the unit is on, andthe monitor is stationed inside the main compartment of theunit, the monitor automatically moves into the viewingposition and switches to CAMERA mode upon reversedriving. When the reverse driving stops, the monitor returnsto the main storage compartment.If the monitor is in display mode, the monitor automaticallyswitches to CAMERA mode upon reverse driving. When thereverse driving stops, the monitor returns to its original inputmode.Aspect RatioPress the WIDE button (28) on the remote control or WIDEbutton (22) on the monitor to adjust the aspect ratio asfollows (only active with video source):Image SettingTable 2 shows the video output mode for each playingsource.*CVBS – Composite Video Baseband Signal24Extender Mechanism- ClosedExtender Mechanism- Fully ExtendedTable 2: Video Output ModesPlaying Source Video Output ModesRADIO RGB ModeSAT RGB ModeDISC RGB ModeBT RGB ModeAUX 1 CVBS ModeAUX 2 CVBS ModeNAV RGB ModeCAMERA CVBS ModeCINEMAThe entire screen is extendedhorizontally to the aspect ratio of 16 to9. The extension ratio is the same atany point.NORMALThe conventional display image has a4 to 3 ratio of horizontal to vertical,leaving a blank area on the right andleft sides of the display.STANDBYScreen becomes black. Touch screento resume.