Axis 212 PTZ Installation Manual

Also see for AXIS 212 PTZ: Specifications Product guide Datasheet Installation guide Product review guide

Contents

Axis 212 PTZ Installation Manual Manual pdf 5 page image

AXIS 212 PTZ/-V Installation Guide Page 5ENGLISHInstalling the hardwareRefer to the illustration on page 4 for a detailed overview of the AXIS 212 PTZ/-V. Make a note ofthe serial number (S/N), which is located on the product label on the base of the camera unitcasing. The serial number is used in the installation.Wall mount1. Using the drill template, drill two holes in the ceiling/wall.2. Route the required cables. See Connect the cables on page 6 for details.3. Fasten the camera unit using screws and plugs appropriate for the wall material.4. Proceed to Connect the cables on page 6.Angled wall mount1. To install the camera at an angle from the wall, use the angled wallmount.2. If necessary, cut the plastic to route the cables to the camera(AXIS 212 PTZ only).3. Install the angled wall mount on the wall using the appropriatescrews and plugs.4. Use the supplied screws (12mm) to attach the camera unit to theangled wall mount. The camera must be mounted with the networkconnector facing upwards.5. Proceed to Connect the cables, below.Note:The AXIS 212 PTZ/-V can be mounted with the network and power cables routed throughthe wall or routed through the side openings. There are cover plates for the openings on thedome casing. The camera must be mounted with the network connector facing upwards.Ensure that the camera is placed so the tamper-proof screws can be tightened using thesupplied screw driver.! IMPORTANT! - The casing of the AXIS 212 PTZ/-V is not approved for outdoor use -the product may only be installed in indoor environments.Networkconnectorup