Page 14 AXIS 231D+/232D+ Installation GuideAccessing the AXIS 231D+/232D+ from the InternetOnce installed, your AXIS 231D+/232D+ is accessible on your local network (LAN). To accessthe camera from the Internet, network routers must be configured to allow incoming traffic,which is usually done on a specific port. Please refer to the documentation for your router forfurther instructions.For more information on this and other topics, please visit the Axis Support Web atwww.axis.com/techsupResetting to the Factory Default SettingsThis will reset all parameters, including the IP address, to the Factory Default settings:1. Disconnect power from the camera.2. Press and hold the Control button and reconnect power.3. Keep the control button pressed until the Power Indicator flashes amber (this may takeup to 15 seconds).4. Release the control button.5. When the Power Indicator displays green (which can take up to 1 minute) the process iscomplete and the camera has been reset.6. Re-install the AXIS 231D+/232D+ using one of the methods described in this document.More informationIt is also possible to reset all parameters, except the IP parameters, to the original factorysettings via the web interface. For more information, please refer to the online help and theuser’s manual. The AXIS 231D+/232D+ User’s Manual is available from the Axis Web site atwww.axis.com or from the Axis Network Video Product CD.