| 
AXIS COMMUNICATIONS Quick User’s Guide2 About This DocumentThis manual is intended for administrators and users of theAXIS 262+ Network Video Recorder and is applicable forfirmware release 4.01. It includes instructions for using andmanaging the AXIS 262+ on your network. Previousexperience of networking will be of use when installingand using this product. Later versions of this document willbe posted to the Axis Website, as required. See also theproduct’s online help, available via the Web-basedinterface.Safety Notices Used In This ManualCaution! - Indicates a potential hazard that can damage theproduct.Important! - Indicates a hazard that can seriously impairoperation.Do not proceed beyond any of the above notices until youhave fully understood the implications.Intellectual Property RightsThis product contains licensed third-party software. See themenu item “About” in the product’s user interface for moreinformation.Legal ConsiderationsVideo recording can be prohibited by laws that vary fromcountry to country. Check the laws in your local regionbefore using this product for surveillance purposes.Electromagnetic Compatibility (EMC)This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used inaccordance with the instructions, may cause harmfulinterference to radio communications. However, there is noguarantee that interference will not occur in a particularinstallation. If this equipment does cause harmfulinterference to radio or television reception, which can bedetermined by turning the equipment off and on, the user isencouraged to try to correct the interference by one ormore of the following measures: Re-orient or relocate thereceiving antenna. Increase the separation between theequipment and receiver. Connect the equipment to anoutlet on a different circuit to the receiver. Consult yourdealer or an experienced radio/TV technician for help.Shielded (STP) network cables must be used with this unitto ensure compliance with EMC standards.Europe - This digital equipment fulfills therequirements for radiated emission according to limit B ofEN55022/1998, and the requirements for immunityaccording to EN55024/1998 residential, commercial, andlight industry.Japan - This is a class B product based on the standard ofthe Voluntary Control Council for Interference fromInformation Technology Equipment (VCCI). If this is usednear a radio or television receiver in a domestic environment,it may cause radio interference. Install and use the equipmentaccording to the instruction manual.LiabilityEvery care has been taken in the preparation of thismanual; Please inform your local Axis office of anyinaccuracies or omissions. Axis Communications ABcannot be held responsible for any technical ortypographical errors and reserves the right to make changesto the product and manuals without prior notice. AxisCommunications AB makes no warranty of any kind withregard to the material contained within this document,including, but not limited to, the implied warranties ofmerchantability and fitness for a particular purpose. AxisCommunications AB shall not be liable nor responsible forincidental or consequential damages in connection with thefurnishing, performance or use of this material. AxisCommunications AB cannot be held responsible for any dataloss in the event of a hard disk failure.PrecautionsPlease observe the following when using the AXIS 262+:• Operate this unit at the correct voltage (12V DC), using othervoltages may cause fire or electrical shock.• The use of UPS is highly recommended.• This AXIS 262+ is a precision machine. Please handle thisunit with care. Vibration and shock could damage the unit soplease use the original packaging if moving the AXIS 262+.• Wait 30 seconds before moving the AXIS 262+ afterdisconnecting the power supply to avoid damaging the harddisk.• Exposure to water or moisture may cause fire or electricalshock. If water gets inside the unit, disconnect it immediatelyand contact your dealer.• Please disconnect the power supply cable if the power supplyhas been turned off.• Do not open the cover or touch the internal components.• Do not use or set the unit where it might be exposed tovibrations or shocks; direct sunlight, rain or snow; flammableor corrosive gas; extreme hot or cold temperatures; humid ordusty conditions; strong electric shock and magnetic fields.• To extend the lifetime of the unit, keep the operatingtemperature below 40ºC.• If the temperature is below 0ºC, the unit must be turned on atall times.Trademark AcknowledgmentsInternet Explorer, LAN Manager, Linux, Microsoft, UNIX,Windows, WWW are registered trademarks of the respectiveholders. Java and all Java-based trademarks and logos aretrademarks or registered trademarks of Sun Microsystems, Inc.in the United States and other countries. Axis CommunicationsAB is independent of Sun Microsystems Inc.WEEE DirectiveThe European Union has enacted a Directive 2002/96/ECon Waste Electrical and Electronic Equipment (WEEEDirective). This directive is applicable in the EuropeanUnion member states.The WEEE marking on this product (see right) or itsdocumentation indicates that the product must not bedisposed of together with household waste. To prevent possibleharm to human health and/or the environment, the product mustbe disposed of in an approved and environmentally safe recyclingprocess. For further information on how to dispose of this productcorrectly, contact the product supplier, or the local authorityresponsible for waste disposal in your area.Business users should contact the product supplier forinformation on how to dispose of this product correctly. Thisproduct should not be mixed with other commercial waste.Support ServicesShould you require any technical assistance, please contactyour Axis reseller. If your questions cannot be answeredimmediately, your reseller will forward your queries throughthe appropriate channels to ensure a rapid response. If you areconnected to the Internet, you can:• download user documentation and firmware updates• report problems to Axis support staff by logging in to yourprivate support area• visit the Axis Support Web at www.axis.com/techsup/ |
