Axis M3011 Installation Manual

Also see for M3011: Datasheet User manual Datasheet Datasheet Installation guide

Contents

AXIS M3011/M3014 Installation Guide Page 5ENGLISHInstall the camera1. Check the package contents against the table on page 3.2. Drill a hole (70-76mm, 2.75 - 3 inches) in the ceiling to fit the camera’s metal camera moduleholder.3. Remove the camera from the metal camera module holder.4. Carefully push and set the three springs on the metalcamera module holder back into their slots.5. Pull the network cable through the ceiling and throughthe camera’s metal camera module holder.6. Insert the metal camera module holder through theceiling. Ensure that Viewing area marked on the rim of thecup faces the area that is to be monitored.7. Fix the metal camera module holder into the ceiling. Insert aninstrument such as a screw driver into the metal camera moduleholder and release the springs so they clamp down on the ceilingand hold the cup in place.8. Attach the cable to the network connector (supports PoE class 1) inthe camera. If PoE is not supported by the network switch, use thesupplied PoE midspan/power injector to connect power to the AXIS M3011/M3014 NetworkCamera.9. Check that the indicator LEDs indicate the correct conditions. See the table on page 13 forfurther details.10. Align the camera arrow with the camera module holder arrow and insert the camera into themetal camera module holder.11. Turn the camera so that the camera arrow points to Viewing area marked on the rim of themetal camera module holder.12. Proceed to Assign the IP address, on page 6.Note:If the camera module holder is mounted onto a hard ceiling such as metal or wood, themetal camera module holder can be screwed onto the ceiling, and the springs can beremoved.camera arrowcamera moduleholder arrow