Axis P1343-E Installation Manual

Also see for P1347-E: Datasheet Installation guide User manual User manual

Contents

Page 10 AXIS P13-E Network Camera Series Installation GuideInstall the camera on the bracket1. Install the camera with the bottom cover on the bracket and tighten the bracket screws.2. Remove the gasket from one of the holes in the bottom cover, see illustration on page 11.3. Route the cable through the hole and attach the cable gasket to the hole.4. Connect the cables, see Connect the cables, on page 11.5. Loosen the bracket adjustment screw to aim the camera to the point of interest and focus thecamera according to the instructions under Adjust zoom and focus, on page 18. See Access thevideo stream, on page 17 for information on how to view the video stream.6. Take the top cover and attach the safety wire to the tab on the bottom cover.7. Install the top cover. Make sure to tighten diagonally opposite bottom cover screws a few turnsat a time until all are tight. This will help ensure that the bottom cover gasket is compressedevenly. Do not attempt to tighten the screws completely the first time.8. Install the cable cover and tighten the cable cover screws.9. Loosen the sun screen adjustment screws and adjust the sunshield to the front position.Cable coverBracket screw (4x)Cable cover screw (2x)Network cable (routeWall bracketBracket adjustment screwthrough wall bracket)Cable holes