Axis P1365 Installation Manual

Also see for P1365: Installation guide User manual Installation guide

AXIS P1365 Network CameraConnectors and ButtonsFor specifications and operating conditions, see page 13.Network ConnectorRJ45 Ethernet connector with Power over Ethernet (PoE).NONONOTICETICETICEThe product shall be connected using a shielded network cable (STP). All cables connectingthe product to the network shall be intended for their specific use. Make sure that thenetwork devices are installed in accordance with the manufacturer’s instructions. Forinformation about regulatory requirements, see Electromagnetic Compatibility (EMC) onpage 2.I/O ConnectorUse with external devices in combination with, for example, tampering alarms, motion detection,event triggering, time lapse recording and alarm notifications. In addition to the 0 V DC referencepoint and power (DC output), the I/O connector provides the interface to:• Digital output – For connecting external devices such as relays and LEDs. Connecteddevices can be activated by the VAPIX® Application Programming Interface, outputbuttons on the Live View page or by an Action Rule. The output will show as active(shown under System Options > Ports & Devices) if the alarm device is activated.• Digital input – An alarm input for connecting devices that can toggle between an openand closed circuit, for example: PIRs, door/window contacts, glass break detectors,etc. When a signal is received the state changes and the input becomes active (shownunder System Options > Ports & Devices).Power Connector2-pin terminal block for power input. Use a Safety Extra Low Voltage (SELV) compliant limitedpower source (LPS) with either a rated output power limited to ≤100 W or a rated output currentlimited to ≤5 A.Audio ConnectorThe Axis product has the following audio connectors:• Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal.• Audio out (green) – 3.5 mm output for audio (line level) that can be connected toa public address (PA) system or an active speaker with a built-in amplifier. A stereoconnector must be used for audio out.For audio in, the left channel is used from a stereo signal.12